CAT6 Gigabit Network Surge Protector 24V SPD

• Customization: Available
• Communication Mode: Full-Duplex & Half-Duplex
• Type: Ethernet Switch
• Model NO.: A-GE-24V
• Transmission Rate: 10/100/1000Mbps
• Ports: ≦8
• Standard: 802.3af/at
• Power Output: 90W
• Transport Package: Carton Box
• Specification: 15*12*5cm
• Trademark: POEPLUS
• Origin: China
• HS Code: 8504401400
• Production Capacity: 10000PCS/Month

Product Description

Cat6 Gigabit Network Surge Protector Model: A-GE-24V

The model is designed to protect high-speed communication network from lightning over-voltage, transient over-voltage and static discharge. The protector implements multi-level protection circuit with advanced manufacturing process, and has excellent performance on discharge current, limiting voltage, response time, stability and over-all reliability.
FEATURES:

Multi. Protection circuits, Gas-Tube+ TVS technology
Dual protection in Common module and different module
TVS array technology, low capacitance
Multi-Strike Capability

 

Model	A-GE-24V
Electrical Parameter
Nominal voltage (Un)	24V
Max. continuous operating voltage Uc	30V
Nominal discharge current(8/20µs)In	2.5kA
Max. discharge current   (8/20µs)Imax	5kA
Limiting voltage (10/700µs) Up
Line-line	60V
Line-ground	500V
Adapt transmission rate	1000Mbps
Insertion loss Ae	0.5dB
Protection line	1-8
Response time Ta	1ns
Interface form	RJ45
Mechanical characteristics
Dimension	100(L) ×38(W) ×28(H)mm
Weight per unit	100g
IP grade	IP20
Working conditions	Temperature: -40 to 80ºC, Relative humidity: ≤95%
Standards Compliance	CE, FCC, RoHS, ISO9001

INSTALLATION AND MAINTENANCE

1. The SPD should be connected in series between the protected device and the signal/power transmission channel.
2. The input terminal (IN) of the SPD should connect to the signal/power transmission channel, and the output terminal (OUT) of the SPD should connect to the protected device.
3. Connect earthing wire of the SPD to earthing bus-bar of the lightning protection system of the room or building.

No special duty needs to be carried out for maintenance. When problem arises and the SPD is suspected, check the system with SPD taken out of circuit. Should system recover, the SPD shall be regarded as a damaged unit and must be replaced immediately.